RingĪ clever bracket design allows you to mount the Ring motion sensor on either a flat surface or in a corner, where it can monitor a bigger area.Īnother detail is how you open the contact sensors to replace their batteries: The sensor cover simply slides off the part that is mounted to your door frame. That’s just one of many seemingly insignificant details that demonstrate the thought that Ring put into this system. I’ve seen too many of these devices where the adhesive covers the holes, so the pads get all twisted up when you put screws through them. You’ll need to provide your own screws, but the holes go through the pads. The contact and motion sensors have adhesive pads applied to them to make installation quicker, but these devices also have screw holes if you want something more permanent. All the new components are backward compatible with the first-generation Ring Alarm, and all first-gen Ring components can be used with the new system. It has a rechargeable battery, or you can run it on AC power with the included adapter. The keypad comes with a wall-mount bracket or it can be left on a tabletop. But these buttons are non-functional unless you sign up for Ring’s professional monitoring (more on that later).Īll 18 buttons on the keypad are now backlit, where only the numeric buttons on the original model were. The new keypad used for arming and disarming the system now has three dedicated buttons for summoning police, fire, or medical assistance. The base station is the only component that didn’t benefit from a redesign in the second-gen Ring Alarm system. Chipmaker Silicon Labs says sensors using Z-Wave 700-series chips should be able to last 10 years or more, although Ring itself more modestly says only that battery life depends on usage. That should yield a second important benefit to consumers: Longer range and improved battery life. The reductions are thanks, in large measure, to Ring’s decision to use the new Z-Wave 700 chip in those components. Each of the new sensors and the new range extender have an LED-backlit button that lights up when the sensor is activated, although you can override that behavior. The contact sensors you’ll mount to your doors and windows are smaller. The keypad for arming and disarming the system is smaller. With the exception of the base station that connects the Ring Alarm system to your home network, every Ring Alarm component has been hit with a shrink ray. But again, the focus of all these products-ranging from cameras to smoke detectors to connected lighting products to smart locks-is on home security, not the comfort and convenience aspects that define a smart home. The system can be expanded and enhanced with a wide range of specialized add-on products from third parties (via the Works with Ring certification program) and Ring itself. That will add $10 per month to the overall cost of the system, but it doesn’t require a long-term contract. To get the most value out of the system, you’ll also want to sign up for a professional monitoring service that will summon first responders in the event of an emergency. Ring sent us a eight-piece kit consisting of the Ring base station, a keypad for arming/disarming the system, four contact sensors, one motion sensor, and one range extender with a battery backup. Ring Alarm 2 is available in several starter kits. The new Ring keypad (right) is much smaller than the original, and it has dedicated buttons for summoning emergency responders (although you need to pay for monitoring to enable that feature).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |